Metal roofs, shingle roofs and honest repairs for Denair, CA homeowners. Family owned since 2002, and estimates are always free.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Denair.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
A skylight has to be woven into the roof, not caulked to it. That is the difference between a fix that lasts a season and one that holds.
One leak usually has company. We fix the one you called about and check over the rest of the roof while we are already up there.
From a few tabs to a whole slope, we fix shingle roofs without pushing you toward a replacement you are not ready for.
When a roof is genuinely finished we replace it, and we say so plainly rather than dressing it up. Metal and shingle priced side by side so you can compare real numbers.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
We match the guard to your trees and your gutter profile, and make sure water can still get in where it is supposed to.
Where it makes sense we set low slope metal over a problem section so it finally drains instead of ponding after every rain.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
Temporary cover goes on fast, then we come back and make the permanent repair once we can see properly what we are working with.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
Buying, selling, or just want to know how many years you have left? We look, we tell you, and we do not turn it into a pitch for a roof you do not need.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Denair homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Denair home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Denair homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
The questions that come up on just about every estimate we write.
Sometimes. If the decking is sound and there is only one layer of shingles, a Denair metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Most Denair houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
A typical Denair shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Any dry stretch works. We roof in Denair year round, though we schedule shingle work for when it is warm enough for the strips to seal properly, and we watch the forecast so your house is never left open overnight.
Much less than people expect. Over solid decking with underlayment under it, a Denair metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
We do. After a storm we photograph the damage on your Denair roof and write an itemized estimate you can hand to your adjuster. We do not file the claim for you and we will not promise you what an adjuster is going to approve — that is their call, not ours.
Honest words from customers who trusted Roofing Brothers with their roof.
"Our church needed a new roof and the budget was tight. They worked with us on it, did beautiful work, and finished before the fall revival."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Hail came through and they had photos and a written estimate to my adjuster in two days. Made the whole claim about as painless as it could be."
Our crews cover the surrounding area, not only the city limits.